Chosen Solution
Hi guys, I recently dropped my 6s with a case on, and now both cameras and flash aren’t working. I opened it up for inspection and noticed that there are multiple pads without a resistor on top of them. It is C5313_RF and C5314_RF. Is it possible to jump these? I’m fairly competent with a soldering iron and will buy a micro tip if needed.
For anyone that happen to have the same problem, replacing the camera with a known working one fixed the issue.
First, check in the schematic to make sure they are definitely not “no stuff” components, where nothing is supposed to be located. Don’t jump them, just find out the value of these and order them from farnell/mouser/digikey, or remove the same value component from another dead board (if you have one about)
There is “no stuff” on those http://imgur.com/a/vJWud. Is camera just blank and frezzes when you switch between them, or it switches normally just both are blank? Also those are suppose to be capacitors, would not be a good idea to jump them, you will create a short
