Chosen Solution

i have the same issue but when i unplug the power supply cable and jumper pin 1 to 1 and pin 9 to 8. no light on logic board but the fan did a quick move.

disneydoxies, first I would do what Apple suggest for the troubleshooting:" The Computer Will Not Turn On. The Display Remains Black and There Are No Sounds From the Fans or Drives.

  1. Verify the power outlet is good. Plug a different device into the socket to ensure there is power, or plug the iMac into another outlet. Does the iMac power on now? Yes: Resolved. Bad outlet. No: Go on to the next step.
  2. Check the power cord. Use a known good power cord. Does the iMac power on now? Yes: Your power cord has failed. Replace the AC power cord. No: Go on to the next step.
  3. Check the connection of the power cord on both ends. Verify that the power cord is securely plugged into both the AC outlet and back of the computer. Does the iMac power on now? Yes: You may have a loose fit to your power cord. Replace the AC power cord and test. No: Go on to the next step.
  4. Follow instructions in the General Information chapter to reset the SMC. Does the iMac power on now? Yes: Issue resolved. No: Go on to the next step.
  5. Remove and reinstall the SO-DIMM memory modules, located in the bottom of the computer. Does the iMac power on now? Yes: Issue resolved. No: Go on to the next step.
  6. Remove the memory access door and front bezel to gain access to the four diagnostic LEDs. See “Diagnostic LEDs” in the General Information chapter for complete instructions on this procedure.
  7. Plug the power cord into the iMac and the power cord into the AC outlet. Check to see if LED #1 is On or Off. LED #1 is On: This indicates that the power supply is getting good power from the AC outlet. Go on to the next step. LED #1 is Off: This indicates that the computer is not detecting AC power. If both the AC outlet and the power cord are good, replace the AC/DC power supply. If the issue persists, replace the AC line filter.
  8. Press the power button. Check to see if LED # 2 comes On, comes on momentarily, or stays Off. LED # 2 is On: The Power Supply is functioning. Go on to the next step.T LED # 2 comes on momentarily or stays Off: Replace the Power Supply.
  9. At this point in the Power On process, you should hear a boot chime and see that LED #1 and #2 are On. Do you hear a boot chime? Yes: The power systems of the computer are working correctly. See “Troubleshooting No Video” in this chapter. No: The logic board is not passing the Power-On Self Test (POST). Replace the SDRAM with known-good memory and test. If the issue persists with known-good SDRAM, replace the logic board.