Chosen Solution I just got an iPhone 4. I set it up with a passcode so no one would go through it. My friend tried to unlock it, and now it’s disabled to the point where I have to connect it to iTunes to enable it. I didn’t have a chance to connect it to my iTunes before he did that. When I try to connect it to iTunes, it says that I have to remove the passcode, but I obviously can’t....
Chosen Solution I’m switching iphone backs and my new one is missing that pin that the power button bracket lays on. So how do i remove this pin if tried everything I used a small paper clip. I snipped off a piece roughly the same size as the pin in the case. Then I used the tip of a screwdriver and a hammer to gently pound it into place and make it flush with he edge....
Chosen Solution I am wondring if ifixit can provide this part: Iphone 6s, 6s plus, 7, 7plus 128GB (or higher) nand flash memory chip. If not. Where do i find them? You can find them here, among other places. They will even program the serial number as an option. Keep in mind that the Naviplus Pro programmer will not work on these PCIE NAND, you need a newer and more expensive programmer....
Chosen Solution My iphone 6s had a bad battery when I bought it from one of my friends. I was aware of it too but was just looking for a backup phone. One day my 6s just stopped charging and eventually died. Tried multiple cables to see if maybe it was just a bad cable even tho they all worked with my Xr. Eventually I just bought a battery and replaced it....
Chosen Solution If I replace the logic board example with this iPhone 6 Plus Logic Board - Verizon / 16 GB would that get the phone of the black list? Guy Sort of… If you replace the logic board with one that is in proper condition, then yes. It will work just fine. However, going from what you’ve said, or phrased this, you can’t use an iPhone 6 logic board, in an iPhone 6S....
Chosen Solution How do you set the throttle position sensor? @gypsyboy , John Fagan , Use the 1st link below, a detailed guide (Toyota 2.4L/3.0L Throttle Position Sensor) adjustment. Good luck. I hope this helped you out, if so let me know by pressing the helpful button. http://www.4crawler.com/4x4/CheapTricks/… http://www.lcengineering.com/LCTechPages…
Chosen Solution Ok, so when I turn on my MacBook. The screen is black but there is damage to the LCD, I believe. I’m just wondering, would it be cheaper to go a 3rd party to fix it? How much will it cost approximately? Will Apple be cheaper given the limited availability of the screen assembly? Can the LCD be replaced alone? The main answer I’m looking for is how much this is gonna cost me....
Chosen Solution It may depend on the age and quality of your notebook, such as it being a high and or low-end machine It may depend on how much do you use it and where do you use it What’s puzzling to me that I haven’t found any guidance on Apple’s web site of the whole issue, have you? Or, according to Apple, you shouldn’t be bothered about cleaning the fan at all, until it gets broken?...
Chosen Solution I have Samsung grand prime which is stuck in reboot loop while trying to root it and is displaying firmware upgrade encountered an issue and to add difficulty and my bad luck its power button is damaged. so if in any corner of this world any angel get to know my situation then please help me…. serious help needed. Re-flash the firmware via ODIN. Data only gets wiped if you manually do it in recovery mode via ‘Wipe Data / Factory reset’ Guide on how to flash Samsung Firmware....
Chosen Solution i have a ps3 40g the disc drive doesnt work but i have a new drive that works can some one tell me how to install a new drive mark, “Use this guide to replace your PlayStation 3’s Blu-ray disc drive. Replacing a defective Blu-ray drive with a replacement requires swapping the Blu-ray drive board from the old drive onto the replacement.”
Chosen Solution There’s a 1.3mm T3 that I can’t get out. I read the info on putting solder into the head, but I’m not sure I’ve got the skill to carefully do that. I’ve tried a rubber band, super glue, and using larger sizes. I think I’ve now got a nice round hole in the screw head. Any other ideas to try? I’d made it half way through the battery replacement guide when I hit this!...
Chosen Solution My Bezel Housing or Chassis Is Battered and is Peeling Off Causing The Phone At Some Angles To Look Very Unattractive. I Recently Bought A New Bezel Housing And I Would Like To Know How To Install it Without Breaking Anything Or Forgetting To Connect. Like this? https://m.youtube.com/watch?v=5jy5BOBWvi…
Chosen Solution I’ve been considering buying some faulty phones, finding what’s wrong with them, buying replacement parts and repairing the device. I’m a comp Sci student and I think it’d be a lot of fun and a great learning experience and maybe I can resell them once they’re repaired. However I’m not sure how to check the function of each individual hardware component. What software would I use to test the functionality of a smartphone’s SoC?...
Chosen Solution I lost my phone password @chido12, Brian, You did not give us much info. to go on here, like make, model, carrier,etc.. So what I will do is post a couple generic links that tell how to factory reset a Android Phone which may work for you. Good luck. I hope this helped you out, if so let me know by pressing the helpful button. http://www.greenbot.com/article/2458403/… http://visihow.com/Recover_Android_Devic…
Chosen Solution I need help finding a 4.7µF 20% 25V capacitor in a 0402 package on Digi-Key It would be greatly appreciated if someone could help @hellomacos Digikey does not have that package size (0402= 1.00mm x 0.5mm) for this cap. The closest you come is is 1.6mm x 0.80mm. If you have enough room (use a set of calipers) you can use that for as long as the ends reach the solder pads on your board....
Chosen Solution I have black areas inside the screen after i drop it … The outter glass is okay and the touch works well Replace the LCD panel. The black is the cracked LCD. But if your screen is laminated (if there is an obvious gap between the display and the glass) you need to get the LCD with the glass on it. Use this screen replacement guide up to step 13 to only remove the LCD: Dell Inspiron 13-7359 Screen Replacement
Chosen Solution I have checked all the fluids and replaced the oil and oil filter. Now I have an inspect (Inspection light on) in dash. I tried to reset and it remains on during starting only. Can someone tell me what I should do next? For Keyless Start: Start with car turned off: For Inspection Reminder Reset: Turn on Emergency Flashers. Then press and hold Reset/0.0 Button on instrument cluster and push the Engine Start button (without starting engine - foot off brake)....
Chosen Solution Hi. I have a 13” macbook pro retina display (Early 2015 model) and I accidentally dropped it from my sofa onto the ground (about 1 feet). There is no crack or lines on the screen. But the screen and backlight will intermittently black (stay off). I connect my macbook pro to external display and it works fine. It seems like there is an issue with my lcd screen. Could you please advise whether this could be lcd connector problem or I have to change the entire lcd screen set to fix the issue?...
Chosen Solution Hello, I have MacBook Pro 13’’ Early 2015 with masOS Catalina version 10.15.4 (latest version available). I have distorted colors, especially white and grey one. It does not do this all the time, sometime it suddenly start to work properly again but just for couple of minutes. It started yesterday and it keeps repeating more often. Any ideas on how to fix this or what is even wrong with it?...
Chosen Solution I recently took my laptop into apple to get the battery replaced, but when they opened it up they saw that the cover to the IO board cable had fallen off, and they said they can’t replace the battery unless they also replace the entire IO board, which made the costs go up significantly. I decided I didn’t want to have it repaired by apple, and I am just going to replace the battery myself....
