Posts

Chosen Solution First off, I’m a complete idiot and probably caused long screw damage in either one or both of the bottom screw holes. But from what I’ve read about LSD, it should only cause the backlight to stop working, right? Maybe the display? This phone seems completely dead as it’s not recognized by iTunes, and gives no response to power regardless of whether the battery is actually plugged in. I don’t feel it getting warm either, but I guess that could be explained a couple different ways....

Chosen Solution Replaced battery still not turning on at all. In the beginning it just quit abruptly Try a new Charging port, LCD, and battery, plug it into a computer to see if it comes up in iTunes. Check the Logic board for corrosion. Basically do a full diagnostic on it. If it doesn’t work, Take it to a local repair store to see if they could do a diagnostic on it (they most likely will)....

Chosen Solution I have an iPhone 6s and I replaced the lcd, when I powered on the device everything was good for about a day. It worked fine, suddenly a message appeared “unable to setup touch ID”. Made a hard reset but nothing, I restore all setting but nothing, replaced the lcd but nothing, restore to factory setting but nothing. Then I decided to install the broken original lcd but again NO TOUCH ID....

Chosen Solution My LeapPad froze and it won’t turn on or off. Is there a way to hard restart it? If turning the device off and on does not reset your device properly you may need to preform a computer reset. In order to do this you must download Leapfrog connect to your computer. Then, put your device in “connection needed mode” by holding down the right D-pad button and the home button while simultaneously turning on the device....

Chosen Solution the network card does not show up in the device manager and I’m figuring the network card fried, or needs to be set properly. How do you get to it, and if required, how do you replace it? hp dv4 1120us entertainment notebook pc Win Vista upgraded to Win 7 Hi, I think it is under HDD cover, near to the HDD. There are two wires (black and white) connected to it....

Chosen Solution Hi! At your retina display disassembly the glass has broken. Due to there is no frame or cover for the panel it’s possible to bring the same forces to it as you did by “showing it the technican”. Now my question: What have you done exactly? How easy is it to bring the destroying forces to the panel at daily use? Thanks in advance. Hi Michael, great question. The reason we had such a hard time with the glass is because of how thin it is and how strong the adhesive holding it down was....

Chosen Solution I dropped Coca Cola on the keyboard. The computer is still working but trackpad and keyboard keys are stuck and very hard to push. How can I fix/clean it? It’s a better solution to buy a new top case like this one? MacBook Pro 15" Retina (Late 2013-Mid 2014) Upper Case Assembly Don’t trust the “it’s still working”, don’t use it until you have checked internal conditions, don’t plug in magsafe and disconnect battery from the logic board....

Chosen Solution Help! How to clear cache, cookies or browsing history on mac safari? Hi, Goji.R You can clear cache, cookies or browsing history on mac safari by CleanMyMac 3 https://youtu.be/vALzGgjFTOs Click Safari in the upper left hand side of your screen. In the menu that appears, click Preferences. In the window that appears, click the Privacy tab. Click the button Remove All Website Data…. Click Remove Now in the pop up window that appears....

Chosen Solution Hi guys, Im just the new member on this site. I have a question that keep in my mind year ago. I got iMac late 2009 27inch and obviously as we know it comes with 4 slots of memory ram. However, I can’t use the other 2 slots at the back (not the front). I thought it may get stuck of dusts in side the slot, I tried to do different ways but can’t make it work....

Chosen Solution Hello, The rear camera of my 2-year-old 1st-generation iPhone SE no longer focuses on any object regardless of distance. So far, I have externally cleaned the lens, updated the OS to iOS 14.3, and have made sure that it has more than 60 GB of available memory space. How might I diagnosis the cause of this malfunction? For that matter, if it’s not the iOS, available memory space, or dirt on the surface, then what might be the cause?...

Chosen Solution I had to remove som keys to clean them. They popped out easily and I was able to attach them back again too, except the space bar. Does anyone know how to attach it back? This machine is covered under Apples Keyboard Service Program for MacBook, MacBook Air, and MacBook Pro https://support.apple.com/keyboard-servi…

Chosen Solution TImer knob spins freely both ways. will not engage timer wheel beneath it to set spin or wash cycle. does not engage in either the in or out position. I know how to take top contol off but cannot release knob…please help See if this video answers your question: http://www.youtube.com/watch?v=qqGys85pk…

Chosen Solution Hi i broke off the motherboard power connector how do i fix it please help If you haven’t broken the pcb, it or a new one could be microsoldered back on Not for beginners. Or you could get a new circuit board Nintendo DSi Power Board Replacement Nintendo DSi Power Board You have two options here. You can either replace your power jack or your entire motherboard. Replacing the motherboard is far easier than just the power jack, but more expensive....

Chosen Solution i hard reset my phone and now its asking me to put the google account that i sync it to.and i cant remember please help me !!!!! As long as you know your email address you can get your password reset by Google . If you used a computer to set up the account you can go into your browser and retrieve your password and email address . depending on your browser it can be done through the options and security

Chosen Solution the lines do not appear on a screen grab and do not clean off???? @yeltep looks like bad diffuser sheets. It is physical part of your display and thus won’t show on a screen grab. you could try and see if you can disassemble the panel and replace the sheets or you may need to look toward a replacement panel.

Chosen Solution A couple of days ago i replaced my charging port on my 5s now my touch id will not work. It’s possible you damaged your flex cable, on your home button. Try putting the old lightning dock (charging port) and then see if the Touch ID works, to make sure the new lightning dock (charging port) isn’t the problem Just do a hard reset (press standby button + home button till the phone restarts), it will start working....

Chosen Solution I am repairing a iPhone SE 2020 and restoring True Tone with my QianLi iCopy plus 2.1 is not working. (I have both the original screen and a new replacement one.) I have used the same iCopy to reprogram a iPhone 8 screen and it worked fine. I assumed that since the iPhone 8 screens are compatible with the iPhone SE 2020 and vice versa that the iCopy would function as expected....

Chosen Solution iPhone 6s sent in for repair, the fault description given is “Main Bat line is shorted | Probably PMIC is burnt” The phone is completely unresponsive - if the diagnosis above is correct - is the data definitely lost? was advised that they need to wipe the phone to repair. No power management ic needs to be replaced for phone to work again. To get data back you fix the phone until it turns on....

Chosen Solution I have owned and returned two of these units for several reasons. My first unit had an audio issue, and the second unit had yellow tint. Will ifixit attempt to tackle a repair for the yellow tint issue. Some claim its because of the way the lcd is installed because the dell monitor of the same panel doesn’t have the issue. The cause of the yellow colouration is easy....

Chosen Solution So, I dropped my phone in the sink while I was cleaning. I turned it on, as I have had zero experience with possible water damage and it was just a little bit unresponsive, fairly slow and there was some ghost touching. A couple days later, these blue and red lines were running down it and I can not access my phone without being quick, and even then I can’t do anything....