Chosen Solution How can i Add setting widget on my screen i don’t see widget setting in screen setting category and how can i setting my password to number . i don’t want to use my finger to swipe on point to point that to slow . thanks for your answer XD Hi, Here’s a link to the user manual for the phone. Scroll down to and click on the green Download Oppo F1s ColorOS 5....
Chosen Solution it flipped the whole screen. I just want the camera screen rotated Guideline to rotate picture for ASUS K52F laptop computer I received the following information from ASUS Customer Service: http://support.asus.com/download.aspx? Chicony Camera Driver Version V061.005.200.300 The following steps worked for me. Enter this address: http://support.asus.com/download.aspx? I had already identified the model number for my ASUS Notebook: K52F (this should work with other model numbers also) Using the Download tab, I selected the Operating System (OS): Windows 7 64bit Next, scroll down and select: Camera (6) Now scroll down to version V061....
Chosen Solution Where can I buy a replacement battery? Hi @joshuaheart , Here is a link to what I believe is a replacement battery for your player. If you look at the guide posted by @alphapeaches you will notice that the battery has the following parameters (I think) 3.7V 180mAH 502025. The 502025 are the dimensions of the battery. This equates to 5.0mm deep x 20mm wide x 25mm long. You can verify this if you disassemble the unit as per the ifixit guide and view the information written on the battery, as it is not easy to discern from the images in the guide....
Chosen Solution I need the screen part number for my vizio E60-C3 is cracked I need to replacement Hi, Open the back of the TV. On the back of the screen will be stamped a number. This is the screen part number. It will not have been made by Vizio but by another manufacturer that specializes in screens Search online by using this number only. Do not add Vizio or TV etc to the search term....
Chosen Solution I replaced the lightning connector and now my microphone won’t work. Did I get a faulty part? The headphones (also a part of that piece) work ok, and the charger works about as good as it did before it was replaced (intermittent). Small parts, such as charge port flexes, sensors etc. tend to have high defect rates; you probably just got a bad one. Contact your supplier/vendor and have it replaced....
Chosen Solution I spilled milk on my macbook pro keyboard, and while I got most of it out (I think) there are still some problems. I’m pretty sure it got under also. It only turns on while charging, and it says that battery should be replaced or it won’t hold as much power. Its resting in rice right now, with some occasional hair dryer blowing, and I’m working on getting a pentalobe screwdriver to open it up....
Chosen Solution I want yo know how to change the display on the evic on my wj 2000 Grand jeep Cherokee Laredo From the compass/temp CT To display distance to empty @nonie , Leonie, The WJ Overhead console and EVIC link below may help. Good luck. I hope this helped you out, if so let me know by pressing the helpful button. http://www.wjjeeps.com/evic.htm
Chosen Solution Hello guys, i replaced my iPad 4 front panel after it was broken but now i have the problem that the new digitizer only reacts at the top and bottom area, in the middle of the screen it doesn’t response. I thought the Digitizer is damaged so i took a new one but same problem only in different areas. What can it be? Is it again maybe a damaged digitizer or maybe a short circuit some where or something else?...
Chosen Solution Hello, I have replaced the entire front assembly on my ipad mini 2 (home button & IC chip) and now the lock button only powers on and off the device, it does not lock the device. Also, the home button doesnt work, at all. The touch is also glitchy, doing things by itself or making it hard to do things. Does this mean the screen is faulty or it hasnt been installed correctly?...
Chosen Solution even though the water damage sticker is ok. what should i do? i can barely see the screen but i can see the screen and every thing is working (i think). is this because of the lcd or the 6r8 coil thing. Thanks for your help Angus, the is a somewhat tricky question. The actual backlight is in your LCD, whereas the 6R8 is part of the backlight circuit that controls the light....
Chosen Solution iphone 4 battery connector damaged / capacitors missing. tried jumping it but the 4 capacitors have broken off image @gsm123 this board has definitely seen better days. Looks like all of your solder pads have been lost as well. Not sure what or why you would try to apply jumpers. If you needed to you could have connected the battery connector like this: Anyhow, neither here nor there and time to move on....
Chosen Solution Hi everyone. I have an iphone 5 that wouldn’t charge. Hard resetting didn’t work. It just wouldn’t power on or charge. The phone is approximately 3 months old. I can’t go to Apple because I went before and they told me that the phone looks like it have been tampered with so the warranty is void. To my knowledge, Apple techs were the only individuals to go inside the phone....
Chosen Solution Battery was replaced, and found out lighting connector was worn out, intermittent charging/connection, changed lighting connector but battery is not charging also noticed battery does get very warm on discharge, currently at <20% charge. Device will boot up on connection when plugged in. You have ruled out parts so it would point to one of the charging IC’s on the logic board either Tristar or Tigris. This repair would require a repair shop that offers microsoldering....
Chosen Solution Iphone 6s - Plugged into power and starts charging. It sometimes charge and sometimes randomly stops charging. In that case, I only switched-off wall power button and upon switching-on, phone starts charging. Nothing change, no loose connection, no cable re-insert, only wall button off/on works. How phone is behaving like this, is there any problem ??? I would say that when troubleshooting charging issues, I would do the following (in order): Always try another Lightning cable and charger, preferably Apple original or MFi certified units....
Chosen Solution How do I remove a ASA dial from a Fuji Film Fujica ST605N camera? The ASA dial is screwed down by a single screw in the middle of the dial. Using plastic rod or wood dowel that is just the same diameter of the head of the screw which then has a piece of rubber attached to its end you can fashion a friction screwdriver to unscrew the slot-less screw....
Chosen Solution I’m doing a project of fixing my old Xps 15z laptop starting by replacing the screen and the connector cable from the LCD to the motherboard (provided that it isn’t soldered). Hi, Here’s a link to the service manual for the laptop. Scroll to p.81 to view the necessary pre-requisite steps and then the procedure to remove the display assembly. This will enable you to remove / replace the LVDS cable....
Chosen Solution I have successfully replaced the logic board and the system is running great. Is there an available tool that works to set the serial number for the logic board? It is currently the default setting, “System Serial#”. Generally you don’t. Only Apple Technicians have access to the software to accomplish this. If this answer is acceptable please remember to return and mark it. Apple certified service technicians uses Apple netboot diagnostics called AST to serialize a newly replaced logic board....
Chosen Solution Hello. I learned all 21 screw sizes of the lg v20 is different or all are is same ?? I need all 21 screws but i dont know what is the sizes of that. If someone measure that and say to we ? Thank you. @lokeui go ahead and just purchase the complete set of screws from places like this
Chosen Solution My parents own this tablet they haven’t had it long and my mother was playing a game on it and its frozen completely. You can’t exit the game or anything and it won’t turn off at all its just stuck on the game no sound or anything. Its been this way for a little while now and is getting warm please advise what to do and what could of caused it....
Chosen Solution All I get is static. Hi @nytryder26, It looks like the AM/FM radio antenna is in the rear quarter window or rear window (not sure which) and the roof shark fin antenna is for GPS and SDARS reception . Here’s an image from the 2013 service manual showing the component layout for the AVN unit which shows the two antenna units i.e. the shark fin antenna and the radio antenna (Item #10)...
