Chosen Solution I don’t know if it is a hardware or software issue (even though every other app and the interface is working fine) with the camera. But every time I try to open the app it says “Camera error : Can’t connect to the camera.” Then it force closes on me and says “Unfortunately Camera has stopped.” This problem is most likely caused by faulty wiring and/or a broken camera....
Chosen Solution how to put a radiator on Tina Hughes, here you go:" CAUTION: As long as there is pressure in the cooling system, the temperature can be considerably higher than the boiling temperature of the solution in the radiator without causing the solution to boil. Removal of the pressure cap while the engine is hot and pressure is high will cause the solution to boil instantaneously - possibly with explosive force - spewing the solution over the engine, fenders and the person removing the cap....
Chosen Solution Dear Ifixit or others, I was trying to lock the fpc cable (for lif/zif ssd) to the fpc connector. But I accidentaly broke the pins in the connector. See attachments. I ordered a fpc connector(see last picture) but I don’t if this is the right one. Update (04/22/2017) On the left it says 40 and on the right 1A. Does anyone know what type of connector this is and where to get it?...
Chosen Solution While in record mode, my phone has frozen. How do I unfreeze it? I’ve tried turning the phone off, but nothing happens. I’ve tried taking the SIM card out, but nothing. How do I take the battery out of this phone? Will that work? Try holding the power button and volume up button at the same time, until the phone gives three short vibrations. Then it will turn off, and you should be able to start it again as normal....
Chosen Solution I’ve got a Mid-2007 white MacBook and i got a black topcase. I want to swap the white and black keys and keep the white topcase to make my Mac look cooler. The new keyboard has the new functions keys (Dashboard, exposé, etc) but my MacBook hasn’t… Is there a way to make the multimedia keys F7-F10, the brightness and volume work? The main issue here is that you must install the upper case that has the functionality you are wanting (Expose, etc)....
Chosen Solution Hello all I have a HP Pavilion model 15-P243sa ( beats audio ) , CPU N3540 (2.16ghz) , 8GB ram, 1TB HD. Out of warranty, but well looked after and more recently the screen in the top right hand corner has become slightly dark. I have Googled the issue and found some similar topics and tricks to remedy the problem, which resulted in no solution. https://h30434.www3.hp.com/t5/Notebook-V… I have updated the BIOS and done a factory reset and still no fix!...
Chosen Solution I have a bulb out in one of my lamps. Can someone come over and change it, please. Please be sure the wattage is consistent with what the lamp can handle. I prefer soft white and am a GE fan, but any manufacturer will do. Also, I don’t really like the energy saving flourescent as they cast a ghastly green shadow on my otherwise ghostly complexion. Well, as iFixit doesn’t really offer services, I’ll try to walk you through this in as clear a manner as I can....
Chosen Solution I am looking for part number 593-1352 A Do you have this or are you able to get it? Steve Latour, you might want to direct your question to the ifixit staff at http://www.ifixit.com/Info/contact The “answers” section is mostly non-ifixit staff that tries to help others with the repair of their devices. Good Luck.
Chosen Solution The only time I get sound is when I plug in headphones or speakers if I unplug them there’’s no sound at all. Hi, No sound from the internal speaker but sound from the earphones usually indicates that it could be anyone of the following conditions : Faulty internal speaker Faulty wiring connection between speaker and mainboard. Faulty earphone jack - the earphone jack has contacts inside which “break” the audio connection away from the speakers when the earphone plug is inserted and the audio is directed to the earphones....
Chosen Solution Hi. I replaced two iPad air 2 Digitizer’s/Lcd on clients devices and on one of them, the device shows the Apple logo for about 10 seconds, goes red then shuts down. This loops. It does boot at times into a fully working iPad which you can use but it again at times just turns it self off. I did disconnect the battery so I’m wondering if I’ve got a bad connection?...
Chosen Solution Hello. I have an iPhone 6s that does not charge and it does not turn on. Only when I insert a new battery turns the iPhone on. When the battery runs out I have to put another. The battery is discharging quickly. I think the bug will be in the charging chip tristar, but I do not know for sure. Somebody have some experience with this problem? Thank you for answear....
Chosen Solution Is there any sure-fire way to tell if the light bulb is actually broken? I don’t want to buy a bulb and end up realizing that it isn’t the source of the problem. There are a couple ways to tell if the bulb is working properly. If there is any light projecting out of the lens, the light bulb is most likely not the problem. However, if there is no light, use the light bulb repair guide to remove the bulb, proceed to shine a flashlight through the bulb corridor into the projector....
Chosen Solution I’m not sure what to do after I plug in the camera to the computer in order to see the photos on my computer. @ariel91 ,Ariel, You did not state your computer make/model or which windows version,etc.. So find some what generic ways to transfer and view your pictures from camera. Link #1 is for win7, link #2 is for win8, link #3 is for win10. The 4th link is for your camera’s manual, software and trouble shooting....
Chosen Solution First, I know this is not the appropriate place to ask the question but I believe people here can help and I don’t want to miss out on getting in touch with them. I need to read data from a smartphone/tablet digitizer for my project. (it will be then process with Arduino/RPi or similar computer) (please direct me, if you know someone who can help) Thank You. It’ll certainly be an interesting project but I don’t think it will be easily accomplished....
Chosen Solution The Logitech MX Keys keyboard has a feature that will light the backlit keys when your hand is in proximity to it. I can’t see any sensors and wondering if it’s some kind of magnetic field detection? Harrison Davies the MX Keys keyboard uses two proximity sensors. One is a proximity sensor that uses a magnetic field to turn on the backlighting and number two is a ambient light sensor, which adjusts the brightness to match the ambient light...
Chosen Solution I dropped my OnePlus one before 2days and the silver bezel get scuffed and i want to know how replace it or repair if their is a chance ? Please answer because I don’t want to see this phone’s beauty destroyed by this sucff . I will very thankful if you answer me . Here you go https://www.youtube.com/watch?v=0YYhGtk9… http://www.etradesupply.com/oneplus-one-…
Chosen Solution How do I increase volume on receiver? Hi @johnalan , To increase or decrease the receiver volume, during a call, simply press the up or down arrow button (found in centre of phone, below the screen) to get the desired volume
Chosen Solution is there a way of filling in the scratches on an apple screen instead of using abrasive methods such as toothpaste, baking soda or others? I don’t have apple care or 300 dollars to replace the screen, so I would like to know if there is another way of fixing it. Any kind of abrasion will affect the oleophobic coating so while you may buff out the scratch, you will also see the effects on the glossy finish....
Chosen Solution Is the back of this phone glued on? I can get it to come off some from the top and bottom of the phone, but it feels like i’am going to break it if I pry to hard. Just hold the single button on the side of phone until it turns back on. May take about 30 sec to a minute You arent supposed to open the back of the ZTE ZMAX....
Chosen Solution How do I replace battery door?? Henry Gill this guide should be pretty identical to your camera. Follow it right up to step 4. You will see a small pin that pushes through some hinges on the battery door, you will have to remove that by pushing it out. Careful!! There should be a small spring on the inside of the door (by the hinges) make sure that you notice the way it is attached....
