Posts

Chosen Solution hey, I dropped my phone on the floor , then the screen became black , but the phone still working actually, I can hear the notification and the music etc .. how can I fix in my home .. cause I really luv this phone . THnxx ♥ Hi Jessie, This sounds like the inner AMOLED screen has been damaged, unlike lcd, when an AMOLED screen gets damaged, it tends to be blank and doesn’t show anything....

Chosen Solution hye everyone.. i forget security code for my nokia 6500 slide.. when i off the phone and on back it must enter the code. i can’t remember it..and the fon also can accept my sim only. i also can’t remember the code..what should i do? i also have USB -cable..please everyone help me for this problem.. you need to contact the network provider for a pin unlock code “PUC”....

Chosen Solution …..i have to do thermal paste and have ruined a screw head badly on thermal sink. I have tried all the solution available online but no luck.Could anyone please help me here. You need a screw extractor set. They are not very expensive. Make a starter hole with a small drill bit. Then place the extractor tip in the starter hole you drilled. Slowly turn the extractor counterclockwise and press down until you feel the extractor threads bite into the screw head....

Chosen Solution Hello, I am having issues after installing caddy disk hard drive in my laptop because I accidentally broke my hard drive connector while opening. Another issue is that usb keyboard is not working with laptop (laptop keyboard is damaged) Now when i turn it on black screen appears saying Intel(R) Boot Agent GE v1.3.81 Copyright (C) 1997-2011, Intel Corporation PXE-E61: Media test failure, check cable PXE-MOF: Exiting Intel Boot Agent....

Chosen Solution I accidently put the pentalops in the wrong places (where the display cables connect) while doing a display replacement and now the device won’t boot even after I got the placement right. Did I damage something crucial and how can i fix it? Thanks I didn’t even know that the pentalobe had the same screw thread as the logic board screws… Chances are you overtightened the screws and damaged the pcb beneath the standoffs....

Chosen Solution After I spilled water, I cleaned with paper towel. It was working fine , I still turned it off, now I was going to use it, but when I plugged the charger it just does not work. The light does not turn on to show that it is charging? So the laptop is not turning on because of low battery or I dont know if somethings wrong with it?...

Chosen Solution Hi I would like to know the location of Bios chip of Microsoft surfce pro 5 model number 1796 Thanks Motherboard PCB: M1007506-015 I think it’s the Winbond W25Q128FV. You can find it in the teardown of your device. It’s highlighted in dark blue. I’m not 100% sure, but I think that’s the one. Before you proceed, maybe someone else here knows it. You are correct, it is the W25Q128FV on the 1796 pro, I cannot get a read from a chip clip type reader using my programmer I believe I am making good contact, Some chips won’t read when installed or maybe my chip went bad....

Chosen Solution I forgot where i need to put this metal piece on my ipphone 5s That little piece belongs under the charging port so the charging port was removed. That piece I’m thinking is some type of grounding for the charging port, if you forgot to put that piece back in during the repair you should put the piece back to avoid future problems. I tried to attach a picture to of where that piece goes on the phone....

Chosen Solution 1994 honda accord coupe had water pump replaced. Idling is high. Overheating occurs quickly. Cant figure out where the water is coming out of. Should radiator be replaced? Tina, check your radiator hoses to make sure they are properly clamped and that the hoses are okay. If so, it is possible that your radiator is leaking. Any shop should be able to do a pressure test to see exactly where it leaks....

Chosen Solution I bought a replacement iPhone x screen a few months back and lately, it has been randomly dragging the screen up and it will stay there until I touch the screen and it has started doing it more and more frequently. Im serverly disappointed as I spent a decent amount of money on this screen and it doesn’t even function correctly :/ I put in the waterproof gasket and everything aswell....

Chosen Solution The iMac 27" 5k 2017 comes with both fusion drive (small m2 like SSD and a HDD) and only SSD. Is the full SSD placed in the m2 slot or the 3,5" HDD slot? So can you buy a iMac 27" 2017 with a 512SSD and put a 6TB HHD in it? If you buy a new Apple system with only a SSD you are getting a PCIe blade drive which sits on the backside of the logic board....

Chosen Solution Will My Mac (iMac5,1) Work with one 2gb stick of Ram and one 1gb stick, or do I have to cave in and buy two 2gb Sticks, only to be able to access 3gb? The maximum memory in your machine is 3 GB. Is is not installed in pairs. Your 2GB & 1 GB sticks should work fine together. Supports 667 MHz PC2-5300 DDR2 SDRAM Here’s a guide on it: http://www....

Chosen Solution My iPad won’t charge at all. It would have the charging logo and after about 30 min, then the Apple logo will pop up and it will go back to Charging. Please help me. Considering the age of your iPad Mini, it is probably a dead battery. You can look at this guide to see what is involved in doing this repair. The mini’s are not the easiest iPad to fix so if you don’t feel comfortable doing it yourself, look for a reputable repair shop in your area to do the repair....

Chosen Solution I am replacing the screen on an iphone 4s for my first time and i have started putting the new screen in, i slid the digitilized through and put everything together but it is too short and won’t reach the motherboard, i have seen many posts saying that you just havnt gotten the whole chord through the hole, well im pretty sure that the whole chord is through and wont budge anymore, here are some images of what i am dealing with....

Chosen Solution Hi guys, I have an iPhone 6, both cameras and flash not working. Tried known working cameras, made no difference, both cameras don’t work. So I know it must be the motherboard. As usual I removed and replaced the camera IC U2301. Tested it again. To my surprise, bother cameras still don’t work. I then removed the new U2301 again, did a jumper from A1 to A2, now capacitor C2345 has constant voltage 3....

Chosen Solution Hey if I bought a 6S plus camera assembly would it work on my regular 6 Plus? No I’m afraid it won’t. bobwhytebrand, iPhone 6 Plus rear and front camera/cables are different from 6S Plus and are not compatible. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.

Chosen Solution Hi guys, right now iam working on iPhone 7 with bootloop, restore done sucessfully, 4 jumpers under audio + replaced audio ic from donor board but nothing does not help. I have 2 same devices with same problem. I tried also disconnect homebutton, front camera, rear camera dock but it does not help. Any idea where can be problem? Thanks @refectio Did the boot-loop occur after the Audio IC repair or was the boot-loop the root issue and you tried an Audio IC repair to solve it?...

Chosen Solution Looking for step by step instructions on how to replace the trackpad. I will be purchasing a replacement trackpad for my 2009 MacBook Pro. I’m wondering if the instructions come with it. No, their won’t be any instruction sheet with the part. But, we have you covered here! OK, You’ll need to follow two different guides as we don’t have one guide that covers the whole procedure. Follow this guide here first: MacBook Pro 15" Unibody Mid 2009 Battery Replacement This will get you to the trackpad which is just underneath it....

Chosen Solution I am looking to put some better RAM into my laptop. How would I go about doing this? To upgrade your RAM you will need to remove your current RAM and insert your new one. The link attached shows you how to access your RAM through the back of your laptop. Asus X555LA-SI305041 RAM Replacement how many slots for RAM have this laptop ? Hey, to UPGRADE the RAM you just add or replace the RAM in the side slot in your guide, however if you need to REPLACE the RAM, one is built in and soldered so that one cannot be replace by the end-user....

Chosen Solution I need to replace my touchscreen but I can’t figure out how to turn it off so I can safely open it. I know about the hold “power button + vol down” to hard reset it but I need it to stay off. Thanks for any help. Hi @yelpats You may just have to carefully open it and disconnect the battery as soon as it is accessible. As long as you can avoid operating the buttons and touching the systemboard with metal tools etc (or fingers), i....